Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

show adjacency int command in cef

hi every body!

I need some help with the following:

switch# show adjacency fastethernet 6/1

protocol int address

ip f6/1 100.100.100.1(9)

What is"9" in the above line?

00d004823400800

epoch:0

what is epoch in the aboce line?

thanks a lot and have a nice day!

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: show adjacency int command in cef

Sarah

Have a look at this link - scroll down to the table and all the output is explained. Please come back if you need further clarification.

http://www.cisco.com/en/US/tech/tk827/tk831/technologies_tech_note09186a0080094303.shtml#topic1

Jon

5 REPLIES
Hall of Fame Super Blue

Re: show adjacency int command in cef

Sarah

Have a look at this link - scroll down to the table and all the output is explained. Please come back if you need further clarification.

http://www.cisco.com/en/US/tech/tk827/tk831/technologies_tech_note09186a0080094303.shtml#topic1

Jon

Bronze

Re: show adjacency int command in cef

Thanks a lot Jon.marshall!

New Member

Re: show adjacency int command in cef

Thats the protocol number at which the adjecency is happening.Check this out

http://www.cisco.com/en/US/docs/ios/ipswitch/command/reference/isw_s1.html#wp1011414

HTH

Ullas

Hall of Fame Super Blue

Re: show adjacency int command in cef

Ullas

I'm not sure it does. According to the doc i posted the number in brackets after the IP address is the number of times this adjacency is pointed to by FIB entries.

Jon

New Member

Re: show adjacency int command in cef

hi jon

You document looks correct.I mistook the protocol parameter of command ref in the link i send .

Thanks

Ullas

210
Views
0
Helpful
5
Replies
CreatePlease login to create content