Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

show clock rate on DTE?

Hi community,

is it possible to see the clock rate configured on the DCE side on the DTE side of a serial interface?

Regards, Martin

3 REPLIES
New Member

Re: show clock rate on DTE?

Yes its possible issue the command:

sh controllers serial x/x/x

on both sides

RE

Kamran

Re: show clock rate on DTE?

Hi,

sure on the DCE side this would show the clock rate. But where do you see the clock rate on the DTE side with "show controller"?

Can you post an example?

Regards, Martin

Hall of Fame Super Gold

Re: show clock rate on DTE?

Only certain platforms and cards will show the received DTE clock in "show controller". Others will just say "TX and RX clocks detected".

7608
Views
0
Helpful
3
Replies
CreatePlease to create content