Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

SHOW CONTROLLERS COMMAND

Hello,

When I run a show controllers command I get the following....

HD unit 0, idb = 0x29A82C, driver structure at 0x2A1DF0

buffer size 1524 HD unit 0, V.35 DCE cable, clockrate 64000

AND

HD unit 1, idb = 0x2A7680, driver structure at 0x2AEC40

buffer size 1524 HD unit 1, V.35 DTE cable

Of course much is ommited. I only want the info of DTE or DCE calbleing.

Is the HD 0 the serial 0 and HD 1 the serial 1?

If not what are the HD's?

Is there a better command to find DTE or DCE?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: SHOW CONTROLLERS COMMAND

This is the only command to know what type of cable is attached, and yes 0 and 1 are the serial ports.

Hope this helps, please rate post if it does!

1 REPLY
Hall of Fame Super Gold

Re: SHOW CONTROLLERS COMMAND

This is the only command to know what type of cable is attached, and yes 0 and 1 are the serial ports.

Hope this helps, please rate post if it does!

574
Views
0
Helpful
1
Replies
CreatePlease to create content