Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

show interface command

I believe that the "show interface" commad normally shows interface utilization based on a 5-minute average.  The is a command to modify this for a particular, shorter time frame.  I can't recall what the command is but I know it's there since one of my service providers had me enter it at one time.  Anyone know what this command is?

Eric

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: show interface command

netspec01a wrote:

I believe that the "show interface" commad normally shows interface utilization based on a 5-minute average.  The is a command to modify this for a particular, shorter time frame.  I can't recall what the command is but I know it's there since one of my service providers had me enter it at one time.  Anyone know what this command is?

Eric

Eric

load-interval 30 - 600 (seconds)

Jon

1 REPLY
Hall of Fame Super Blue

Re: show interface command

netspec01a wrote:

I believe that the "show interface" commad normally shows interface utilization based on a 5-minute average.  The is a command to modify this for a particular, shorter time frame.  I can't recall what the command is but I know it's there since one of my service providers had me enter it at one time.  Anyone know what this command is?

Eric

Eric

load-interval 30 - 600 (seconds)

Jon

529
Views
0
Helpful
1
Replies