From what I understand, for DS3 you need to put the bandwidth subscribed in the interface configuration. Both you and your provider should have the exact number, else you will get a lot of error in your interface (i forgot the errors). This is from my experience which I have 2 x DS3 from different location connects to Internet Provider 1 with different bandwidth subscription (FIXED) and 1 x DS3 from another location that connects to Internet Provider 2 with burstable bandwidth up to 45Mbps.
Here is a sample from one of my FIXED subscription of 20Mbps
atm scrambling cell-payload
atm framing cbitplcp
no atm ilmi-keepalive
interface ATM4/1.1 point-to-point
ip address 192.168.1.2 255.255.255.252
vbr-nrt 20000 20000
oam-pvc manage 30
I can't find the config for burstable. I already replaced them with MetroE :) as they becoming more expensive and to think that they are old technology with old infrastructure
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...