Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

show interface: TX load, RX load, Reliability

Can you get a pretty accurate idea of how much bandwidth is being used on an interface by the TX load and RX load stats?

Does this take into account if you have changed the bandwidth description manually on an interface?

Also, the reliability, what is being checked to get that parameter on the "sh interface"?

2 REPLIES
Hall of Fame Super Silver

Re: show interface: TX load, RX load, Reliability

Richard

The calculation of TX load and RX load are based on the configured bandwidth. If you have used the interface bandwidth command to specify a bandwidth value then that is the value used in the calculation. If you have configured an accurate value then you get accurate results and if you have configured a value too high or too low than the real figure then you will get invalid results.

HTH

Rick

New Member

Re: show interface: TX load, RX load, Reliability

Hi,

The best option you can go for is the input and o/p rate on the sh interface o/p. For a more accurate output configure a lesser load interval on the interface.

I hope it helps .

Thanks and Regards,

Srinath.M

Cable&Wireless

2714
Views
0
Helpful
2
Replies
CreatePlease login to create content