Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

Show Logging Messages..

                   I am observeing these logs when i provide the show logs.. What this message denotes.. Every day i am receiving this msg.

Jul 10 11:12:29.900: %IOSXE_PEM-3-PEMFAIL: The PEM in slot 0 is switched off or encountering a failure condition

Jul 10 11:12:29.984:%IOSXE_PEM-6-PEMFAIL:The PEM in slot 0 is functioning Properly.

Jul 10 11:13:29.900: %IOSXE_PEM-3-PEMFAIL: The PEM in slot 0 is switched off or encountering a failure condition

Jul 10 11:13:29.984:%IOSXE_PEM-6-PEMFAIL:The PEM in slot 0 is functioning Properly.

Jul 10 11:13:29.900: %IOSXE_PEM-3-PEMFAIL: The PEM in slot 0 is switched off or encountering a failure condition

Jul 10 11:13:29.984:%IOSXE_PEM-6-PEMFAIL:The PEM in slot 0 is functioning Properly.

1 REPLY
Cisco Employee

Show Logging Messages..

Dinesh,

It may be because of the PEM is not properly seated/screwed in the chassis.

These errors basically indicate that the power supply in slot 0 had failed but

later

recovered by itself

Please make sure you are adhering to the following guidelines

Follow proper safety and grounding guidelines,

verify the installation of the PEM and confirm that the hardware is fully

seated and properly screwed in

Verify that power is connected and turned on. Verify that the PEM is turned on.

For proactive reason you can get the RMA and have the part onsite as spare and replace it if you see the logs pouring after 24 hours.

HTH

Regards

Inayath

*Plz rate all usefull posts.

2003
Views
0
Helpful
1
Replies