Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Show Mac-Address, Speed/Duplex, Vlan, Port

Is there a way on a Cat4506 running IOS to get the dynamic mac-addresses, interface, speed/duplex, and Vlan information from a single command? Can we use the show command | include ????? I'm not sure I know how to get the output. Thanks in advance.

Hall of Fame Super Silver

Re: Show Mac-Address, Speed/Duplex, Vlan, Port

Hello David,

I don't think you can get all this information with a single command.

sh mac-address-table dynamic

sh mac-address-table address

where address is in format aaaa.bbbb.cccc (exadecimal digits)

sh ip int brief

sh int descr

sh vlan id vlan#

all these are useful commands and you can use | include to filter show ouput

Hope to help


Hall of Fame Super Gold

Re: Show Mac-Address, Speed/Duplex, Vlan, Port

Nice one Giuseppe. :)

He can also try "sh interface status" to show the spee/duplex setting, VLAN/Trunk information and connection status.

New Member

Re: Show Mac-Address, Speed/Duplex, Vlan, Port

Thanks guys. I'm familiar with all those cmds. I'm just look for something that will combine several of them to run a report for my boss without having the use a third party application.