Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

show policy-map interface help understanding the output table

I've attached 2 examples of the output from a "show policy-map interface xxx n/n" I want to understand the table that is at the bottom of the output. I have some routers that do not show the table when I issue the command but for the ones that do, what am I looking at? everything to me is clear until I get to the table that shows 8 classes, 0-7 and rsvp information. What are the 8 classes? are these generic CS buckets? what? I have machines using more than one AF class that show only one row of class 0 in the table (also attached).

I cannot find a table explanation on the CCO, only definitions for everything preceding it.

shouldn't the numbers be sums from the classes? they're not.

Thanks in advance.

1 REPLY
Hall of Fame Super Silver

Re: show policy-map interface help understanding the output tabl

Hello Nelson,

if you mean these lines:

>> class Transmitted Random drop Tail drop Minimum Maximum Mark

pkts/bytes pkts/bytes pkts/bytes thresh thresh prob

0 891548776/488485052793 0/0 0/0 20 40 1/10

1 0/0 0/0 0/0 22 40 1/10

2 0/0 0/0 0/0 24 40 1/10

these are related to WRED weighted random detect

WRED is a congestion management tecnique that tries to prevent to have full queue that causes generalized tail drops.

Hope to help

Giuseppe

426
Views
0
Helpful
1
Replies