Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

show post command

Hi.

Is there a command like "show post" on a 2811 router like on a catalyst switch which indicates or shows the status of the "power on self test" after the router is working and finished its power up?

Thank you.

1 REPLY
Hall of Fame Super Gold

Re: show post command

ISR routers don't have POST. You can do "show diag" to see what is installed in the router.

Hope this helps, please rate post if it does!

1840
Views
4
Helpful
1
Replies