Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

show route-map

If I have a route-map that is configured correctly, shouldn't I see packets and bytes increasing when I do a show route-map command?  This is what I see on all my route maps and I wonder if they are even working.

Policy routing matches: 0 packets, 0 bytes

 

3 REPLIES
Cisco Employee

What platform is it?> Can you

What platform is it?> Can you share the config?.

Community Member

Hi thanks for helping out

Hi thanks for helping out.

This is a 7204, running c7200-adventerprisek9-mz.152-4.M2.bin

Here are the eigrp and bgp sections, I removed a few statements, and also the show route-map commands.  The show commands say 0 packets, 0 bytes, so I'm wondering if these route maps are correct?

 

rtr1#sho run | s r b
router bgp 65002
 bgp log-neighbor-changes
 ...............
 ..................
 redistribute static
 redistribute eigrp 1 route-map EIGRP2BGP
rtr1#sho route-map EIGRP2BGP
route-map EIGRP2BGP, deny, sequence 10
  Match clauses:
     tag 10
  Set clauses:
  Policy routing matches: 0 packets, 0 bytes
route-map EIGRP2BGP, permit, sequence 20
  Match clauses:
    ip address (access-lists): ALL
  Set clauses:
  Policy routing matches: 0 packets, 0 bytes
rtr1#
!!!!!!!!!
rtr1#sho run | s r e
router eigrp 1
  ................
  ................
 redistribute bgp 65002 route-map BGP2EIGRP
 redistribute static metric 1500 0 255 1 1500
 passive-interface Loopback0
rtr1#
rtr1#sho route-map BGP2EIGRP
route-map BGP2EIGRP, deny, sequence 5
  Match clauses:
    ip address prefix-lists: novoip_plist
  Set clauses:
  Policy routing matches: 0 packets, 0 bytes
route-map BGP2EIGRP, permit, sequence 10
  Match clauses:
    ip address (access-lists): ALL
  Set clauses:
    metric 200000 100 255 1 1500
    tag 10
  Policy routing matches: 0 packets, 0 bytes
rtr1#

 

Cisco Employee

Hi,What you see is expected

Hi,

What you see is expected behaviour. packet matches will be seen only when you use it for policy based routing. In this case you use the route-map to match the prefix and redistribute which is at control plane. 

 

-Nagendra

1656
Views
5
Helpful
3
Replies
CreatePlease to create content