Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Show running configuration command

I had configured a 1801 and 1750 series router with a line aux 0 for dial-up backup with a speed of 115200, but every time I type the show running config command these line changes to whatever value.

Could you tell why?

1 REPLY
New Member

Re: Show running configuration command

This could be an indication that your router and modem aren't talking to one another. I suspect that the dial backup isn't working like you want it to.

Physical connectivity, aux port config, modem dip switch settings, modem cap, etc.

Check here:

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_tech_note09186a008009428b.shtml

And here:

http://www.cisco.com/en/US/tech/tk801/tk36/technologies_tech_note09186a0080094bbc.shtml

I hope this helps. Please rate as appropriate.

359
Views
5
Helpful
1
Replies
CreatePlease login to create content