Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Show temperature - IOS 12.3, 3745 router

Hi, without SNMP monitoring, can I occasionally check temperature of a router?

The scenario is that I will be deploying few routers and switches in a non-refrigerated computer room and I just would like to see whether I could check the temperature once in a while.

2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: Show temperature - IOS 12.3, 3745 router

Hi,

Kindly use the "show environment" command.

HTH,

Mohammed Mahmoud.

Re: Show temperature - IOS 12.3, 3745 router

HI, [ Pls Rate if HELPS ]

As a continuation of Mohammed Reply:

Execute as below in 3745: for IOS Version 12.3:

Router#show environment

--Output of Show Environment Command--

Power Supply 1 is present.

Fan status: normal

Input Voltage status: normal

DC Output Voltage status: normal

Power Supply 2 is present.

Fan status: normal

Input Voltage status: normal

DC Output Voltage status: normal

48V Power Supply 3 is not present.

48V Power Supply 4 is not present.

Board Temperature: normal.

PLS RATE if HELPS

Best Regards,

Guru Prasad R

2 REPLIES

Re: Show temperature - IOS 12.3, 3745 router

Hi,

Kindly use the "show environment" command.

HTH,

Mohammed Mahmoud.

Re: Show temperature - IOS 12.3, 3745 router

HI, [ Pls Rate if HELPS ]

As a continuation of Mohammed Reply:

Execute as below in 3745: for IOS Version 12.3:

Router#show environment

--Output of Show Environment Command--

Power Supply 1 is present.

Fan status: normal

Input Voltage status: normal

DC Output Voltage status: normal

Power Supply 2 is present.

Fan status: normal

Input Voltage status: normal

DC Output Voltage status: normal

48V Power Supply 3 is not present.

48V Power Supply 4 is not present.

Board Temperature: normal.

PLS RATE if HELPS

Best Regards,

Guru Prasad R

18868
Views
5
Helpful
2
Replies
CreatePlease to create content