Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

simulating a WAN/Frame/VPN connetion between 2 routers

I have (2) 2811 routers and I would like to simulate a frame connection between the 2 routers..Is there a cable or some device that I can use to plug into the T1 cards on each router to simulate a WAN?

4 REPLIES
Blue

Re: simulating a WAN/Frame/VPN connetion between 2 routers

You cannot simulate a Frame Relay network without a 3rd router acting as a frame relay switch.

(you need a device to generate LMI for the frame relay endpoints to receive)

You can simulate a Serial WAN, hdlc, between the two routers using DTE and DCE cables.

Please see the following link for more information:

http://www.cisco.com/en/US/docs/ios/12_2/wan/configuration/guide/wcffrely_ps1835_TSD_Products_Configuration_Guide_Chapter.html#wp1065161

Community Member

Re: simulating a WAN/Frame/VPN connetion between 2 routers

thanks!!!

Hall of Fame Super Bronze

Re: simulating a WAN/Frame/VPN connetion between 2 routers

Please see the following link on back-to-back Frame-Relay:

http://www.cisco.com/en/US/tech/tk713/tk237/technologies_configuration_example09186a0080094a3b.shtml

HTH,

__

Edison.

Community Member

Re: simulating a WAN/Frame/VPN connetion between 2 routers

Back to back frame relay can be an interesting beast, some things I try never seem to work when ever I attempt to do use it. PPP auth over frame-relay (using a virtual template) But that's more than likely a mistake on my behalf :D

I seem to recall reading on another site (it's not mentioned on the cisco site) that you need to issue the command

frame-relay switching

in global conf, I don't get to use frame relay much so i'm not that confident in my FR abilities

250
Views
0
Helpful
4
Replies
CreatePlease to create content