I am trying to create a site-to-site VPN tunnel from a Cisco RV 120W behind a AT&T Uverse router to connect back to our corporate office. I have it connected but I cannot connect the VPN to it because I am behind this other router, all I get in the 192.168.1.x address. Is there any way of getting the Internet IP address to update on my router, any ports I need to forward on the AT&T router, or can this be done this way. The client would rather not replace the AT&T router. Any suggestions on how to do this?
Internet -> AT&T router -> Cisco RV120W router(Mine)
In order to get an IP other than what you are getting, you will need to have ATT give you a static IP. I am guessing based off the info given here that you are getting a DHCP IP from ATT router. Their router is giving out the 192.168.x.x
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.