I've got a Cisco ASA 5520 device at my work place which has been in use for about 6 months now. I just recently purchased a Cisco 857 ADSL router for a branch office and have the internet up and running, but am stuck getting the site to site VPN working. I want to configure it via the SDM and I'm new to setting up VPN's.
I will use ASDM to configure on ASA, but what needs to be changed on my config below to get the VPN running. I'm sure it has something to do with routing / natting. The IPSEC / IKE policies should be mirrored on the ASA side.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...