I Have a WIC/VIC/HWIC Card installed in a Cisco 2800. The Layer 2 is estabhlished but I am get very Large amounts of Slip Sec errors. I have had the Telco check the Line and all appears fine. The Controller is set to Line, but I have also tried Internal. The Telco are convinced this is a Issue with the Wic Card
I do had the same problem, and I put clock source internal under e1 controller and Slip Secs error had gone. I have 6 E1 interfaces bundled as multilink and one of the interface kept getting error which was caused time out after some number of replies when I tried ping remote sites.
I just wanna ask if I have got sever E1 controller, do I need to put network-clock-participate wic X
It`s strange, but I configure clock source to be internal on two E1 (clock source of other 4 E1 forming multilink are line) which are connected to telco circuirs and all Slip Secs error disappeared. I did not configure network-clock-participate at ala on my router. I wonder if it is one of the solution to get rid of slip sec error? Could you explain more about using network-clock-participate and network-clock-select command if possible? thank a lot
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.