Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SLOT0:ON SUP 1-2GE

Hi All!

PS;Have a look to these output when i try to format the PC CARD On slot0:

Console> (enable) format slot0:

All sectors will be erased, proceed (y/n) [n]? y

Enter volume id (up to 31 characters):

Unknown device mfg id (ffffffff.ffffffff.ffffffff)error = -1

Format device slot0 failed (unspecified error)Console> (enable) .

whai is "the Enter volume id"waht should i enter in this field?

10xs for ur help

Ali

  • WAN Routing and Switching
2 REPLIES

Re: SLOT0:ON SUP 1-2GE

Hello Ali,

for the volume id, just accept the default and press return, you do not need to enter anything there. Your problem might rather be related to the PC card not being recognized by the IOS, which could have several reasons, e.g. the card is damaged, or it is a third party card not compatible with the Supervisor. When you do a ' dir slot0:' do you see any files on the card ?

Regards,

GNT

New Member

Re: SLOT0:ON SUP 1-2GE

Hi Friend!

when i issue the Dir Slot0:i dont see any thing.but the Pc Card Is:Cisco system Brand.64-MB linear Flash PC card (MEM-C6K-FLC64M=)..B/W.The the 6509 RUN Catos & ios on the MSFC..

10XS

ALI

114
Views
3
Helpful
2
Replies
This widget could not be displayed.