Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Smart Init

Hi

I have 1841 router. when it reloads it gives following error.Smart Init is enabled

smart init is sizing iomem

ID MEMORY_REQ TYPE

0X003AA110 public buffer pools

0X00211000 public particle pools

0X00020000 Crypto module pools

0X0002 0X0001A800 Card in slot 0

0X000021B8 Onboard USB

If any of the above Memory Requirements are

"UNKNOWN", you may be using an unsupported

configuration or there is a software problem and

system operation may be compromised

Is it a serious problem.

5 REPLIES

Re: Smart Init

Hi, kiran

Since all MEMORY_REQ field has a "KNOWN" name(public, Crypto, etc), there is no problem on your router. Don't worry.

HTH

SSLIN

Re: Smart Init

Friend

Only time you have to worry is when you see unknown besides the memory address displayed

Narayan

Cisco Employee

Re: Smart Init

Is router up and running? What happens if you reload the router.If you reload the router and it goes to rommon mode, then there might be some issue with the IOS.

Paste the output of " show version" if its up. or "set " from the rommon.

-amit singh

Re: Smart Init

Amit

This is a normal boot system message you get and is not an error. There is no problem with his router.

Narayan

New Member

Re: Smart Init

Hi all

Thanks for your suggestions. The router is working fine. I searched in cisco site regarding this message. They had specified to increase iomem size. After increasing the size the message is not appearing.

Once again thx

243
Views
0
Helpful
5
Replies
CreatePlease login to create content