We receive our mail through our ISP. However some of the mail is stuck in their queue with the following error message "status=deferred (conversation with x.x.x.x timed out while sending RCPT TO. this is only for some users though and not all. I have used a network monitor software and our server responds to the RCPT TO with 250 2.1.5 firstname.lastname@example.org | 354 Start mail input; end with . and sends a retransmission after getting no response from the sending server.
We have no anti spam software installed on the server.
We have a Cisco 800 series router. How can I find out why the router is not passing on that particular command. We have NAT enabled on the router. On the internal interface I have noticed that the command "250 2.1.5 email@example.com | 354 Start mail input; end with " is transmitted to the external interface.
We do not have any rules enabled on the router, no firewall and no PIX. How is it possible to tell at what point the command fails and why it fails?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...