Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNA QOS

Hi All,

Need to know how can SNA traffic be prioritized??

Thanks.

3 REPLIES
Blue

Re: SNA QOS

you can classify the traffic with MQC for Bandwidth or % of Bandwidth queuing.

you can use CBWFQ to prioritize traffic sessions into either LowBandwidth or HighBandwidth.

and for low speed links you can use LLQ which again classifies specific traffic to specific bandwidth.

see this link for more info:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_book09186a00800c5e31.html

New Member

Re: SNA QOS

how do we classify??

access-list permit xxx??

New Member

Re: SNA QOS

How do you classify depends on what protocol you use for transporting the SNA traffic over the IP. It's usually DLSW+. The DLSW+ ports are TCP/UDP 2065 and 2067 (depending whether DLSW+ is configured to use UDP or TCP).

If you use RSRB, ports are UDP/TCP 1987 - 1989 and 1996.

So your ACL for DLSW+ could look like this:

access-list 100 permit tcp any any eq 2065

access-list 100 permit tcp any any eq 2067

access-list 100 permit udp any any eq 2065

access-list 100 permit udp any any eq 2067

access-list 100 permit tcp any eq 2065 any

access-list 100 permit tcp any eq 2067 any

access-list 100 permit udp any eq 2065 any

access-list 100 permit udp any eq 2067 any

Similar for RSRB...

Regards,

M.

121
Views
0
Helpful
3
Replies
CreatePlease login to create content