I have two Motorola Routers conected through Frame Relay Service. SNA Switching DLSW working perfectly.
That is all being replaced by Two Cisco Router (2811) connected through MetroEthernet Service. The SNA (DLSW) is not working the "dlsw circuits" does not establish, only the "dlsw peer" gets established.
?Where can i start checking? ?Router config? Im used to making Cisco Routers connect via Frame Relay where you have remote Branch Router and it connects to a Central Site Router where he pushes the MAC address on to the transaccional host work perfectly.
I apply the same logic on the Metro but it just doesn't establish.
?Is this a MetroEthernet type problem?
?What info can I post so that you can help me more?
Don't assume the problem is due to metro ethernet rather than frame-relay. Dlsw design and troubleshooting is kind of a specialized discipline in cisco networking. Can you ask the TAC to look over you config? They have a specialized team for that.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...