SNMP configuration on CISCO routers with IOS older then 12.2
I have some problem. I configured several snmp commands on router with IOS 12.3(5d). I tried it on CISCO 1701 and Cisco 2621XM. These are the commands:
snmp-server community test1 RO 10
snmp-server community test2 RW 11
access-list 10 permit 10.10.10.10
access-list 11 permit 10.10.10.10
Then I try to make snmp request to this router using some ip tool from computer with ip 10.20.20.20 (for example) and i get response from the router. It doesn't matter what is the response the most important is that I get response. When I used IOS 12.4 (7) I had got the same response. But when I used 12.2 version, router did not reply to my snmp packets - and I think it should be the right behaviour. Anyway may be it is new IOS feature - to reply to the PC's snmp request though it's ip is not allowed in access-lists. Could you help me and clarify this. Thanks in advance.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...