Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP not pass though subnets

I have two sub nets on my cisco 2600 (ROM: System Bootstrap, Version  12.2(10r)1, RELEASE SOFTWARE (fc1)

192.168.1.0/24  eth0
&
192.1682.0/24  eth1

I have an smnp server on the .1 nw  and anything on that nw i receive traps but nothing on the .2 nw. Why is  the router not passing through the snmp protocol? Do i need to set  something extra up on the the router?

here is my config

ip access-list standard Replication
remark  deny Replication mask for the DR
deny   172.28.2.0 0.0.0.255 log
access-list  10 permit 172.17.1.8
access-list 30 permit 172.17.2.0 0.0.0.255
access-list  30 permit 172.17.1.0 0.0.0.255
route-map Traveler permit 10
match  ip address 10
set  ip next-hop 172.17.1.54
!
route-map Traveler permit 20
!
snmp-server  community 12Public RO 30
snmp-server community 12Private RW 30
snmp-server  trap link ietf
snmp-server enable traps snmp authentication linkdown  linkup col
snmp-server enable traps isdn call-information
snmp-server  enable traps isdn layer2
snmp-server enable traps isdn  chan-not-avail
snmp-server enable traps hsrp
snmp-server enable  traps config
snmp-server enable traps entity
snmp-server enable  traps envmon
snmp-server enable traps bgp
snmp-server enable traps  ipmulticast
snmp-server enable traps msdp
snmp-server enable  traps rsvp
snmp-server enable traps frame-relay
snmp-server enable  traps rtr
snmp-server enable traps syslog
snmp-server host 172.17.1.110 12Public

Thanks Guys

CCNA
332
Views
0
Helpful
0
Replies