Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SNMP not responding?

        What are the possibilites that a router's snmp would just stop working?

I have a 2811 router that was responding fine to my network management software. The router is NOT within my local network. So we had a nasty power outage where my monitoring server is so we were shut down for 24 hours. When power came back up I haven't had a poll from the router since. I have checked my configurations, changed them, reset them, cycled the router, tried different snmp software, nothing! Is it possible that my router is now just dead to SNMP?          

2 REPLIES
Cisco Employee

SNMP not responding?

Cody,

Check the following link it might be usefull:

http://www.cisco.com/en/US/docs/ios/12_2/configfun/configuration/guide/fcf014.html#wp1001309

Regards

Inayath

New Member

SNMP not responding?

Router#show snmp

6 SNMP packets input
    0 Bad SNMP version errors
    6 Unknown community name
    0 Illegal operation for community name supplied
    0 Encoding errors
    0 Number of requested variables
    0 Number of altered variables
    0 Get-request PDUs
    0 Get-next PDUs
    0 Set-request PDUs
    0 Input queue packet drops (Maximum queue size 1000)
0 SNMP packets output
    0 Too big errors (Maximum packet size 1500)
    0 No such name errors
    0 Bad values errors
    0 General errors
    0 Response PDUs
    0 Trap PDUs

SNMP logging: enabled

I've probably sent 20 get or getnext requests. Not even showing up on the router?!

139
Views
0
Helpful
2
Replies