Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

SNMP polling IPSEC tunnel status

Is there any way to get the tunnel status through a snmpget command ?

snmpwalk -v 2c -c <string> -m ALL <ip> cikeTunRemoteValue

Gives me all active tunnels with remote peer address. that's good. I could work with this output.

The problem is i need to make a snmpget command but when the tunnel is down and up it get's a new index value and the previous snmpget query will not work any more.

202
Views
0
Helpful
0
Replies
CreatePlease to create content