Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SNMP trap

We have a backup interface (dialer2) and we want it to generate a SNMP trap regarding it UP status as soon as it comes up. We tried to change SNMP timeout and queue length but that did not help. Also we cannot specify source interface of SNMP traps in the configuration. How do we make backup interface to generate a trap as soon as it comes up regarding its own UP status and send it to TRAP receiver? Is there any timer that we can fine tune?

1 REPLY
Bronze

Re: SNMP trap

for that you have to use the debug command like logging trap level

Limit messages logged to the syslog servers. By default, syslog servers receive informational messages and numerically lower levels.

http://www.cisco.com/en/US/docs/switches/lan/catalyst5000/catos/6.x/command/reference/sl_w_cmd.html#wp1038714

157
Views
0
Helpful
1
Replies
CreatePlease to create content