Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

snmp

Anyone can explain the below. I want to enable snmp traps and the router gave me the below error message.

FrameSwitch(config)#snmp-server enable traps

% Cannot enable both sham-link state-change interface traps.

% New sham link interface trap not enabled.

1 REPLY

Re: snmp

The error does not mean that traps have not been enabled but says traps about ospf sham-link chnages will not be sent.

In order to send them you will need the foll commands

snmp-server enable traps ospf cisco-specific errors config-error

snmp-server enable traps ospf cisco-specific errors shamlink

Have a look here

http://www.cisco.com/en/US/docs/ios/iproute/configuration/guide/ospf_sham_mib_ps6350_TSD_Products_Configuration_Guide_Chapter.html

HTH

Narayan

5383
Views
0
Helpful
1
Replies
CreatePlease to create content