Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Software upgrade with no ethernet

Hi,

I have a 3640 router with a 2FE2W-V2 but this module is not recognize by the router, due to it I want to make a upgrade software but

my procedure is I connect a cross-cable from the fast ethernet to my pc, so have you an idea how I can make the upgrade without ethernet connection?

Thanks in advance.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Software upgrade with no ethernet

5 REPLIES

Re: Software upgrade with no ethernet

Hi

Well i think u can xmodem procedure for this.

Thanks

Mahmood

New Member

Re: Software upgrade with no ethernet

Thanks Mahmood. Have you an idea where I can to find the procedure?

Re: Software upgrade with no ethernet

New Member

Re: Software upgrade with no ethernet

If you have physical access to the router, change the speed of the console port to as fast as you can get (I've only been able to get up to about 115000), then once you've got that working, just issue a copy xmodem flash. I'd recommend hyperterminal for this as it has a good send feature.

HTH,

Shane

New Member

Re: Software upgrade with no ethernet

It's right, thanks to all for your helps.

103
Views
0
Helpful
5
Replies