We're currently using IP SLA to determine route availability. The way it should work is if an IP address can be reached (ICMP), then static route A is used. If not, then static route B is used. See the code below.
ip sla monitor 1
type echo protocol ipIcmpEcho 10.50.50.1 source-interface FastEthernet0/0.10
ip sla monitor schedule 1 life forever start-time now
track 1 rtr 1 reachability
ip route 10.10.1.0 255.255.255.0 10.20.102.125 track 1
ip route 10.10.1.0 255.255.255.0 10.20.128.16 4
ip route 10.50.50.1 255.255.255.255 10.20.102.125 permanent
ip route 10.50.50.1 255.255.255.255 10.20.128.16
The problem is that it's not failing over to the 2nd static route.
The end result is that we should point traffic to the 10.10.x.x network. Our vendor has provided an address on the 10.50.50.x network to use for purposes of route selection.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.