Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SPA-2XT3/E3 configuration?

Hello,

     I have two 7304 routers.  One is in service and works fine taking a ds3 and dividing that up into several T1 connections going out to remote locations.  I recently received another 7304 router, but inadvertantly ordered the wrong part.  Instead of ordering a PA-MC-T3= (SW) as I have in the original.  I have a SPA-2XT3/E3.  Can anyone direct me to some documentation that I can use to set this up to take a ds3 connection and separate it out into multiple T1's.  Something like this (IOS version is 12.2(33)SB1):

controller T3 2/0

t1 1 channel-group 0 timeslots 1-24

t1 2 channel-group 0 timeslots 1-20

.

.

.

interface Serial2/0/1:0

description 1544k to location1

bandwidth 1544

ip address 192.168.0.1 255.255.255.252

encapsulation ppp

fair-queue

bridge-group 1

!

interface Serial2/0/2:0

description 1120k to location2

bandwidth 1120

ip address 192.168.0.5 255.255.255.252

encapsulation ppp

fair-queue

bridge-group 1

.

.

.

Thanks,

Will

Everyone's tags (5)
1 REPLY
Hall of Fame Super Silver

Re: SPA-2XT3/E3 configuration?

Hello Will,

you can use the following chapter from SPA/SIP configuration guide

http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/configuration/7600series/76cfgt3.html

basically you first need to set the card type ( if T3 or E3 mode)

Router(config)# card type {t3 | e3} slot subslot

but unfortunately it is not capable of channelized operation as explained here in the datasheet

http://www.cisco.com/en/US/prod/collateral/modules/ps6267/product_data_sheet0900aecd8027ca19.html

to be noted a 2/4 T3 only channelized SPA exists and it can be configured with sub T1 see

http://www.cisco.com/en/US/docs/interfaces_modules/shared_port_adapters/configuration/7600series/76cfgct3.html

So I'm afraid you cannot use this SPA for aggregating T1

Hope to help

Giuseppe

1801
Views
0
Helpful
1
Replies