Does this mean, I can configure SPA GE port as a 802.1q trunk, configure interface vlan, and allow that vlan on the trunk. Then configure QOS policy on the interface vlan as if it's the SPA sub-inteface?
Typically on a 6148 card, when you configure interface vlan service-policy, only policing is accepted. No queuing supported. This is the reason I am using a SPA card interface.
"EtherChannel is only supported on the 10-Port Gigabit Ethernet SPA and the 1-Port 10-Gigabit Ethernet SPA on the Cisco 7600 SIP-600. EtherChannel is not supported on the Cisco 7600 SIP-400 or on a Fast Ethernet SPA on the Cisco 7600 SIP-200."
It didnt mention about SPA 5xGE on a SIP600 (7600).
I am basically planning to implement L3 etherchannel with this SPA with multiple POrtchannel sub-interface (VRF-lite).
im agree with you, after spending some time researching on the document, i think its about time you contacting one of cisco engineer to confirm this. if you cant open a TAC case, perhaps you can email to firstname.lastname@example.org, they can engage you to the right team for answering this.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...