Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

SPAN limitation 5600

- What is the effect of removing the SPAN session used by the FWSM installed in the C6513 switch (no monitor session servicemodule).

- Is there an IOS for the 6513 switch that support configuring more than two SPAN sessions on the switch? As the switch currently support two SPAN sessions only.

Hall of Fame Super Silver

Re: SPAN limitation 5600

Hello Ibrahim,

for us that session is a workaround to allow multicast traffic to flow in a FWSM transparent context.

So it has become part of a solution.

the session to the FSWM can be seen only with a sh monitor session all

sh monitor session all

Session 1


Type : Service Module Session

Modules allowed : 1-6

Modules active : 4

BPDUs allowed : Yes

About SPAN sessions see the table



Local SPAN, RSPAN, and ERSPAN Session Limits

the limit is two of local sessions with PFC3 (sup720) and also for PFC2 (sup2)

Hope to help


New Member

Re: SPAN limitation 5600

So, if i remove the SPAN for FWSM it will affect its normal operation

Hall of Fame Super Silver

Re: SPAN limitation 5600

Hello Ibrahim,

removing the SPAN session may affect FWSM or not. this depends on what the FWSM is doing.

if no multicast traffic is going through the FWSM (as in most of FWSM applications) the side effect I've described doesn't apply to you.

So I would suggest to check FWSM configuration before taking a decision.

Hope to help