Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Span monitor session for VLAN 1

We'd like to create a monitor session that covers all the traffic on a Catalyst 6513 switch. The only VLAN currently configured on the switch is the native VLAN 1, so I figured I could span the entire VLAN thus capture all traffic that traverses the switch. However, while the IOS allows me to create the session and enter VLAN 1 as the source VLAN, when I check the session it shows as having no source VLAN configured. Am I not allowed to span the switches native VLAN?

1 REPLY
Hall of Fame Super Silver

Re: Span monitor session for VLAN 1

Hello Patrick,

just a warning even a powerful C6513 can be impaired if the traffic volume is much greater then the destination port speed: we have seen cpu to go as high as 100% on C6509 for a span session trying to push 3Gbps of traffic out a single GE port where the IDS is connected.

the following chapter from ios 12.2SXF can help

http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/ios/12.2SXF/native/configuration/guide/span.html#wp1102614

and the command reference for monitor session command

http://www.cisco.com/en/US/docs/ios/lanswitch/command/reference/lsw_m1.html#wp1015931

it is clearly stated that valid vlan-id is 1-4094 on C6500/7600.

Hope to help

Giuseppe

616
Views
0
Helpful
1
Replies