09-20-2013 09:42 AM - edited 03-04-2019 09:06 PM
I am in the process of adding a new vlan (4) to replace vlan (1)
I know how to configure the trunk. My question is do I need to make any configuration change
with spanning-tree?
Thanks for your cooperation.
Solved! Go to Solution.
09-20-2013 10:31 AM
hi,
yes you're correct
Regards
Alain
Don't forget to rate helpful posts.
09-20-2013 10:14 AM
Hi,
if you had left the default for STP for vlan1 then you can leave STP the same for vlan 4
Regards
Alain
Don't forget to rate helpful posts.
09-20-2013 10:19 AM
just so that I understand... I do not need to make any changes - Correct? Thanks.
09-20-2013 10:31 AM
hi,
yes you're correct
Regards
Alain
Don't forget to rate helpful posts.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide