09-20-2013 09:42 AM - edited 03-04-2019 09:06 PM
I am in the process of adding a new vlan (4) to replace vlan (1)
I know how to configure the trunk. My question is do I need to make any configuration change
with spanning-tree?
Thanks for your cooperation.
Solved! Go to Solution.
09-20-2013 10:31 AM
hi,
yes you're correct
Regards
Alain
Don't forget to rate helpful posts.
09-20-2013 10:14 AM
Hi,
if you had left the default for STP for vlan1 then you can leave STP the same for vlan 4
Regards
Alain
Don't forget to rate helpful posts.
09-20-2013 10:19 AM
just so that I understand... I do not need to make any changes - Correct? Thanks.
09-20-2013 10:31 AM
hi,
yes you're correct
Regards
Alain
Don't forget to rate helpful posts.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: