Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

speed 100 Vs speed 1000

Dear all,

when do we assign to the interfaces speed 100 and speed 1000

please suggest some related links.

thanks,

raj

4 REPLIES

Re: speed 100 Vs speed 1000

HI Raj, [PLS RATE if HELPS]

Pls see the Attachment for various combinations in SPEED Assignments.

PLS RATE if HELPS

Best Regards,

Guru Prasad R

New Member

Re: speed 100 Vs speed 1000

Dear prasad,

thanks for ur document.

please send me related cisco link,

thanks

raj

Re: speed 100 Vs speed 1000

HI Raj,

I don't have any related cisco Link for this.

>> Let me check and keep you updated.

Best Regards,

Guru Prasad R

Re: speed 100 Vs speed 1000

Hi,

Take note that FastEthernet (100Mbps) can be hardcoded to full-duplex but not all GigabitEthernet (1000Mbps) can be hardcoded to full-duplex some even hal-duplex. This is true in some network devices and server/OS (Unix) - I have once hardcoded a Cisco switch to 1000Mbps/full-duplex but I found out that the Unix server that connects to it can only hardcoded to 1000Mbps/half-duplex so I settle with 100Mbps/full-duplex both end of the wire since the maximum bandwidth utilization is around 40Mbps. Packeteer products doesn't allow you hardcoding GE interfaces.

Monitor your bandwidth overtime, if you are not hitting 100Mbps, settle with 100Mbps/full-duplex as the performance is many times better than 1000Mbps/half-duplex. If you need more than 100Mbps, it is best to set GE to auto-speed/auto-duplex both end of the wire, just make sure that the cable is correct and in good quality to a avoid flapping.

Regards,

Dandy

401
Views
3
Helpful
4
Replies
CreatePlease login to create content