Hello, it appears you are running into a hardware limitation in the router. Most entry level routers cannot pass traffic at "line rate", so even though your device has a 100Mbps connection it can't make use of all of this traffic.
According to the following document (Under the "Performance" header) the Cisco 500 series router is rated for ~8Mbps of traffic with "IMIX" traffic (that is a mixture of feature sets like NAT, VPN, ACL's, etc) or ~30Mbps with 1400 byte packets.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...