Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

static binding in DHCP

Pls how do I permanely assign an ip address to a host under dhcp. I cant seem to find the ''address'' command under the dhcp configuration mode....is it normal??/

1 REPLY
Cisco Employee

Re: static binding in DHCP

Hi,

   This setup is called "manual binding" and you can find an example of how to configure this on the following link:


http://www.cisco.com/en/US/tech/tk648/tk361/technologies_tech_note09186a00800f0804.shtml#se

Bear in mind that the configuration is a little different when DHCP client is a Microsoft 
Host or not, the reason is that Microsoft adds a "client identifier" to the MAC address of a
host when sending DHCP requests. The link above explains the difference in configuration in
this scenario (you only add a 01 to the MAC address).

Regards,

Rick.

312
Views
5
Helpful
1
Replies