Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Static Default Route with Object Tracking and DDR Issue

Hi,

There is a 1841 router connected through a primary Metro Ethernet Link 4 Mbps to Internet and a backup ISDN Link through a BRI interface. I have configured a default route pointing Fast Ethernet 0/1 (ME Link) which is tracked with an IP SLA (icmp protocol). When the object is down then a second floating static route with AD 254 is entered in routing table and a call is initiated through the BRI interface. When the object comes up the BRI B channels stay active and the call is not terminated. I have configured the idle-timeout to 100 sec.

Can anyone help to investigate the reason for that behavior?

Thanks in advance!

4 REPLIES
Hall of Fame Super Silver

Re: Static Default Route with Object Tracking and DDR Issue

Hello John,

have you defined a dialer-list ?

it helps to define what is the interesting traffic that reset the idle-timeout timer a too broad definition will cause the link to stay up.

If you like you can post the interesting parts of your configuration

Hope to help

Giuseppe

New Member

Re: Static Default Route with Object Tracking and DDR Issue

interface BRI0/1/0

description *** Link to Secondary Internet Gateway ***

ip address negotiated

ip access-group Internet_Inbound in

ip inspect WEB out

encapsulation ppp

dialer idle-timeout 100 either

dialer string xxxxxxxxxx

dialer load-threshold 1 outbound

dialer-group 1

isdn switch-type basic-net3

isdn point-to-point-setup

no cdp enable

ppp authentication pap callin

ppp pap sent-username zzzzzzzz password yyyyyyyy

ppp multilink

end

dialer-list 1 protocol ip permit

I will try to define the interesting traffic better than now...

Thanks

Silver

Re: Static Default Route with Object Tracking and DDR Issue

Hi

You should also consider the line

dialer idle-timeout 100 either

By default, outbound traffic will reset the dialer idle timer. Adding the either keyword causes both inbound and outbound traffic to reset the timer

this explanation is taken from

http://www.cisco.com/en/US/docs/ios/12_2/dial/configuration/guide/dafiprof.html

Maybe it's traffic coming from other side that is resetting the timer.

/Mikael

New Member

Re: Static Default Route with Object Tracking and DDR Issue

I will try that.

Thanks

137
Views
8
Helpful
4
Replies
CreatePlease to create content