Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

STATIC IP ADDRESS BINDING USING CISCO 1841 ROUTERS

Dear Team

I have configured DHCP in Cisco 1841 router , But the DHCP is working fine .Kindly help me to configure Static binding of IP address in DHCP .he

Today 30-07-2013  I have tested to DHCP using IP mapping with Mac address as per discussion . But finally the static mapping not working . Here with attached the Command list . Please kindly help me to resolve this .

4 REPLIES

STATIC IP ADDRESS BINDING USING CISCO 1841 ROUTERS

what have you tried so far to get it to work?   can you send config.

thanks


=============================
Please remember to rate useful posts, by clicking on the stars below.

=============================

Please remember to rate useful posts, by clicking on the stars below.

New Member

STATIC IP ADDRESS BINDING USING CISCO 1841 ROUTERS

hi ,

after configuring DHCP and all for client bindin you can use belwo command to map it.


ip dhcp pool name-pool-static
host 192.168.0.253 255.255.255.0
client-identifier 0100.xxxx.xxxx.xx (MAC Address of the device)

Thanks

Gajendra

Purple

STATIC IP ADDRESS BINDING USING CISCO 1841 ROUTERS

Hi,

to configure static mappings:

1) look at your dynamic bindings with sh ip dhcp binding x.x.x.x to see what client-identifier the client is using

2) delete the corresponding bindings with clear ip dhcp binding x.x.x.x

3) create your host pools like this:

  ip dhcp pool host_pool

  host x.x.x.x  y.y.y.y  where y.y.y.y is the subnet mask

  client-identifier 01xx.xxxx.xxxx.xx 

   or

hardware-address xxxx.xxxx.xxxx  <<< MAC address

Regards.

Alain

Don't forget to rate helpful posts.

Don't forget to rate helpful posts.

All I'm trying to accomplish

All I'm trying to accomplish is this typing it in the console, but what script it takes to do this!?:

INTERNET---[CABLEMODEM]-d-[Fa0/0[Cisco1841]Fa0/1]-s-(192.168.0.1_.252 (1-host))---[PC]

s=static; d=dynamic

I've been trying to do this since the Cisco 2501; please... trying very hard not to rant.

792
Views
0
Helpful
4
Replies