Basically, what I want to accomplish is a static subnet nat translation from between 10.0.0.0 and 220.127.116.11
But I only want some specific conversations to be NATted, so I added a ACL in combination with a route-map, to specifiy the traffic to be NATted.
When I test the conversations specified in the ACL, the NAT process does add the translation, but only as fasr as the classufll bits count, 10.0.0.0 in this case. Show ip nat translations shows us the following:
R019#show ip nat translations
Pro Inside global Inside local Outside local Outside global
after implementing this in my config, the specific ip connections, did get NATted the correct way, and not just the first 8 bits. All this sounds not clear to me, and I think they have to further investigate this issue.
and this is the answer for the config u have done:
Typically, the ip nat inside source static command is used to translate a small number of entries between your network and two other networks. However, this command provides one interesting parameter: extendable. This parameter causes the Cisco IOS to create an extended translation entry in the translation table instead of a simple entry
example, internal has two Internet connections for redundancy. ISP1 has assigned an IP address space of 18.104.22.168/24. ISP2, which does not support ISP1's address space, has assigned 22.214.171.124/24 to this network. This poses a problem because you need to set up a static translation for the internal web server. Normally, a static statement allows only one translation. In this example, you must choose between 126.96.36.199 translated to 10.0.0.1, or 188.8.131.52 translated to 10.0.0.1 for the web server translation.
Using the extendable parameter, however, you can associate more than one global address with a local address
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.