Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Static port forward range

Hi,

Is it possible to forward a range of ports when using the following command:

ip nat inside source static tcp <ip> <port> <ip> <port>

The only way I can think of is to use a route-map command, but I can seem to get this working.

Regards

Andrew

p.s. I do not wish to use an IP to IP tatic map, I need to specify individual ports

2 REPLIES

Re: Static port forward range

will u clear it in more detail, what u want exactly?

New Member

Re: Static port forward range

To forward ports 5000 to 5200 to an internal IP, without:

A) Putting 200 static entries into my config

B) Mapping a public IP to a private IP

193
Views
0
Helpful
2
Replies