I have a problem. Our network using satellite to communicate with the ship. only using static route to initiate direct connection to our network here in HQ. but if sometimes when the satellite fails we need to physically plug another cable to the other router to initiate dialup isdn. is there any ways to give priority to static route to enable automatic link backup when one of the Satellite is down the link can be up the other side using isdn without mannually change route and plug in cable everytime this case occur.
For what i know static route cannot advertise the fail at the Satellite side only dynamic routing can be able to advertise if the nearest neighbor fails.
*Note the Satellite connection can only use static route.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...