I'm using cisco packet tracer didn't setup everything just trying to learn more from my CCNA. I'm needing to know what else to do? I'm going to post the packet tracer.
From PC4 I can ping router0 and all the rest of the svi but I can not ping router 3 or router 1 I know it's a route issue but can't figure out what command to use. From router3 I can ping pc4 etc so I got that right.
This is odd I redownloaded this packet tracer and loaded it again. It all worked I was able to ping everything. Ok would I have had to do a reload after all those changes? If not then I'm really confused.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.