Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

static route

How to configure two static routes for the same network but different ports one for ethernet and other for the BRI on the same router?

4 REPLIES

Re: static route

Hi,

Without knowing the relationship between the two interface, its difficult to guess.

However, if they are configured as primary/backup. Try floating static route http://www.cisco.com/en/US/tech/tk801/tk133/technologies_configuration_example09186a0080093f7e.shtml

Regards,

Dandy

Silver

Re: static route

you can do like the given

ip route 10.0.0.0 255.0.0.0 fasetethernet0/0

ip route 10.0.0.0 255.0.0.0 fasetethernet0/1 60

60 is the preference, as you are increasing the pref the route will be less prefered.So it will be your secondary route.

regards

shivlu

Re: static route

HI,

If it is the floating static routes use can use the increased AD as 200 for secondary Link.

ip route 10.0.0.0 255.0.0.0 fasetethernet0/0

ip route 10.0.0.0 255.0.0.0 fasetethernet0/1 200

Pls Rate all Informative Post

Best Regards,

Guru Prasad R

New Member

Re: static route

On a MEN, having a floating static route can give issues.

MEN connects to the router through a switch which in turn connects to the providers network through fiber. If there is a fiber cut at the provider's end, the connectivity between the router and the provider switch will still be UP and the routing entry for 10.0.0.0 will still be reachable through f0/0

Traffic will never fall back on f0/1

-Sai.

118
Views
0
Helpful
4
Replies