Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

STM-1 configuration problem

stm-1 card is installed in 7606 router. while making the stm-1 card operational following defects are shown:

SONET 2/1/0 is down.

Channelized OC-3/STM-1 SMI PA

H/W Version : 24.257.2.5, ROM Version : 1.2

FREEDM version : 2, F/W Version : 1.19.0

Applique type is Channelized Sonet/SDH

Clock Source is Line, AUG mapping is AU4.

Medium info:

Type: SDH, Line Coding: NRZ, Line Type: Short SM

Regenerator Section Status:

No alarms detected.

Multiplex Section Status:

No alarms detected.

No BER failure/degrade detected

BER_SF threshold power : 3

BER_SD threshold power : 6

Higher Order Path Status:

Path# 1 has defects HP-UNEQ HP-PLM

how to rectify this so that stm-1 becomes operational

1 REPLY

Re: STM-1 configuration problem

Hi

Can you paste the outputs of show version,show diag and show run config related to the STM-1 port ?

regds

115
Views
0
Helpful
1
Replies
CreatePlease to create content