cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
553
Views
4
Helpful
2
Replies

Storm control for Multicast on CAT6500

shah.chintan
Level 1
Level 1

Hi,

I'm trying to configure following command for Multicast traffic control on FE interface of CAT6500 with IOS version :12.1(26)E1 , Sup2/MSFC2.

I'm getting following error.

MLS-88-2(config-if)#storm-control multicast level 1

Command Rejected: Multicast suppression is not supported on Fa3/6

Can any one help on this ?

Thanks

Chintan

2 Replies 2

jackyoung
Level 6
Level 6

Please check the Cisco doc. as below that only part of the GE support multicast storm control.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_guide_chapter09186a0080160a9f.html

i.e.If you are using FE interface, it can't support.

Hope this helps.

hi,

Thanks. So Whether Sup1/Sup2 , MSFC2 will not support Multicast strom control on FE interface ?

Rgds

Chintan

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: