Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Strange behaviour on a 7304 with SNMP via VRF

HI all,

The thing is when I configure this router to send snmp traps to a host with the command "snmp-server host 10.0.0.1 community" it works properly but if you try to send traps via a VRF with the command "snmp-server host 10.0.0.1 vrf VPN_A community" router shows a very strange behaviour. There is a switch attached to this router and after put this command you lost half of the packets sended to the switch from a pc, any idea?

Thanks in advance.

Regards,

2 REPLIES
Bronze

Re: Strange behaviour on a 7304 with SNMP via VRF

SNMP Support for VPNs allows users to configure an SNMP agent to only accept SNMP requests from a certain set of VPNs. Check out the following link for more info :

http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a00804557c4.html

New Member

Re: Strange behaviour on a 7304 with SNMP via VRF

Thanks for the link, We´ve figure out it is not supported in the 7304 router, but seems strange because in one box works properly while not in other one (both 7304)...

121
Views
0
Helpful
2
Replies
CreatePlease login to create content