03-21-2006 07:15 AM - edited 03-03-2019 12:07 PM
HI all,
The thing is when I configure this router to send snmp traps to a host with the command "snmp-server host 10.0.0.1 community" it works properly but if you try to send traps via a VRF with the command "snmp-server host 10.0.0.1 vrf VPN_A community" router shows a very strange behaviour. There is a switch attached to this router and after put this command you lost half of the packets sended to the switch from a pc, any idea?
Thanks in advance.
Regards,
03-27-2006 07:26 AM
SNMP Support for VPNs allows users to configure an SNMP agent to only accept SNMP requests from a certain set of VPNs. Check out the following link for more info :
http://www.cisco.com/en/US/products/ps6350/products_configuration_guide_chapter09186a00804557c4.html
03-28-2006 04:43 AM
Thanks for the link, We´ve figure out it is not supported in the 7304 router, but seems strange because in one box works properly while not in other one (both 7304)...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: